Brick Workouts in Triathlon: How to Link Bike and Run
You rack the bike, pull on your running shoes, and your first steps feel like a robot walking. Here is what studies measure after cycling, and how to prepare for it.
The KILYO team
The sports coach that reads your workouts
The short answer
A 2022 study published in BMC Sports Science, Medicine and Rehabilitation, on collegiate triathletes, measured a running mechanical efficiency of 42.1% after 40 km (25 miles) of cycling, compared with 48.1% after a prior run. To get used to it, add a short run right after your usual bike ride and start at your target pace.
Key takeaways
- In collegiate triathletes, after 40 km (25 miles) of cycling, running mechanical efficiency drops and energy use without oxygen rises, without a significant change in running economy.
- According to a 2000 review, most running mechanics parameters change little after cycling; the clearest change is a torso leaning more forward.
- After maximal cycling, one study measured differences between mid-level and elite triathletes on two running parameters; they may partly explain heavy legs, without proving it.
- End your usual bike ride with a short run whose length you set before you start, then extend it in steps.
You step off the bike, rack it, and pull on your running shoes. Then your legs don't respond the way they usually do: your first strides feel stiff, heavy, and a little strange.
A brick workout lets you experience that moment in training instead of on race day. Let's look at what studies measure after cycling, then how to build your bike-to-run sessions.
What is a brick workout?
The idea comes down to three steps: you ride, you rack the bike, you run. In triathlon, the run always starts on legs that have just been pedaling. Running and cycling on different days doesn't recreate that. A brick workout does.
What cycling changes in your run
A 2022 study published in BMC Sports Science, Medicine and Rehabilitation compared collegiate triathletes in two situations: running after 40 km (25 miles) of cycling, and running after a previous run. Running mechanical efficiency, meaning the share of energy you spend that actually turns into movement, was lower after the bike.
Energy produced without oxygen (called anaerobic) was also higher after the bike. However, the cost of a given pace, known as running economy, did not differ significantly between the two situations.
These measurements come from collegiate triathletes. They may partly explain the heavy-legs feeling when you get off the bike, but they don't prove it: the study did not measure how it felt.
Your stride changes little, your torso leans forward
Many people assume the stride falls apart completely after cycling. A 2000 literature review on the bike-to-run transition in Olympic triathlon says something different: most biomechanical parameters stay the same. The clearest change is a torso leaning more forward. The mechanics after cycling are still debated, but this older review suggests watching your posture more than your technique: eyes looking far ahead, shoulders relaxed, chest tall.
What the study on mid-level and elite athletes measures
Hausswirth and colleagues compared mid-level and elite triathletes after maximal cycling. In mid-level athletes, the estimated oxygen use of the breathing muscles rose more during the run that followed. Elites also seemed better at adjusting leg stiffness, meaning how the leg absorbs each footstrike. So the transition weighs less on the elites in this study, which is one more reason to build it up gradually rather than discover it on race day.
Building your brick workouts, step by step
The studies cited here measure what changes after cycling. They don't test what a brick workout adds to performance, and they don't set a duration or a frequency. What follows is a cautious approach, not a proven rule.
No single duration works for everyone: it depends on your level and the distance you're preparing for. A better guide is something you can observe: move to the next step once you finished the last brick without a fade and your heart rate stayed in your easy pace zone (you can find it with the heart rate zones tool). If not, keep the same duration.
Here's an example, for illustration only and not as a standard:
- Week 1: 10 minutes of running after your usual bike ride.
- Week 2: 15 minutes, if week 1 went well.
- Week 3: 20 minutes if you held on without a fade, otherwise stay at 15.
Change only one thing at a time: either the bike duration or the run duration. If you're still building your weekly schedule, beginner triathlon with three workouts a week sets the base you can add a brick to.
The first minutes: start gentler than your legs want
Legs that feel stiff or heavy when you get off the bike make you want to speed up to compensate. That's the classic mistake: you don't yet know how they'll respond that day. During this start, judge your run by how it feels rather than by your watch.
What you can do in your next workout
- Pick a bike ride you already do, at your usual pace, rather than a hard session.
- Prepare your transition before you leave: running shoes ready to slip on, water bottle in place, watch set to run mode.
- Set your run duration in advance, for example 10 minutes if this is your first brick.
- Write one sentence about how you felt in the first minutes and at the end.
KILYO reads your bike and run workouts from your watch, compares your pace and heart rate in the first minutes of the run from one brick to the next, and adjusts the rest of your plan.
Frequently asked questions
How many brick workouts per week, and how long should they be?
Can you do a brick workout at home, on an indoor trainer and then a treadmill?
My legs feel very heavy at the start: does that mean I'm poorly trained?
Sources
- Literature review (2000). Physiological and biomechanical adaptations to the cycle to run transition in Olympic triathlon: review and practical recommendations for training. Study summary
- Study on collegiate triathletes (2022). Prolonged cycling lowers subsequent running mechanical efficiency in collegiate triathletes. BMC Sports Science, Medicine and Rehabilitation. DOI
- Hausswirth C. et al. Alterations in running economy and mechanics after maximal cycling in triathletes: influence of performance level. International Journal of Sports Medicine. Study summary
Written with the help of AI.

